The Redde R1 is a solid oxide fuel cell. It turns propane or natural gas into electricity through a chemical reaction rather than an engine. There are two home models with 240-volt AC output: one for propane and one for natural gas.
It works as a battery charger. The R1 connects into a FranklinWH or Tesla Powerwall 3 system the same way solar does, and it reads the battery's charge over your home network. When the grid is down and the battery drops to a set level (50% by default), it starts up. It reaches full output in about an hour. It stops when the battery is back to about 90%, or about 15 minutes after the grid is stable again, and then needs about two hours to cool before it can start again. It can't run without a battery system to connect to, so it only works alongside a compatible battery.
Full output is 1.25 kW, which adds up to about 30 kWh over a full day. The battery still covers the big moments, like a well pump starting or the oven heating. The R1 refills it in the background. If your house uses more than 1.25 kW on average through an outage, the battery still runs down, just more slowly. So sizing starts from your load list, not from the R1's rating. Redde says the R1 isn't meant to back up life-support or medical equipment.
The R1 is still new in California, and our county's plan checkers may not have reviewed one before. Redde requires installers to complete its training and supports each installer's first jobs. We complete that training before we schedule yours, and we prepare the permit set and answer the building department's questions. New to batteries? Start at home battery backup. This page assumes you already have one or are planning one.